Toggle navigation
Home
KPSC Previous Question Papers
Article Category
kerala psc
upsc
General
Popular Pages
Multiple Choice Question in aptitude-area
Multiple Choice Question in non-verbal-reasoning-grouping-of-images
Multiple Choice Question in aptitude-compound-interest
Multiple Choice Question in engineering-mechanics-kinetics-of-a-particle-impulse-and-momentum
Multiple Choice Question in electronic-devices-bipolar-junction-transistors
Multiple Choice Question in 035/2016
Multiple Choice Question in database-database-redesign
Question Answer in malayalam-kerala-psc-questions
Multiple Choice Question in malayalam-kerala-psc-questions
Multiple Choice Question in current-affairs-2017-03-05
Question Answer in KERALA PSC
Multiple Choice Question in KERALA PSC
Question Answer Bank
Multiple Choice Question Bank
Question Answer Category
Multiple Choice Question Category
Home
->
Multiple Choice Questions
Question Set
civil engineering structural design specifications
1. The slenderness ratio of single angle discontinuous struts conmected by a single rivet or bolt, shall not exceed
(A): 110
(B): 130
(C): 150
(D): 180
Previous Question
Show Answer
Next Question
Add Tags
Report Error
Show Marks
Ask Your Doubts Here
Type in
(Press Ctrl+g to toggle between English and the chosen language)
Post reply
Comments
Show Similar Question And Answers
QA->The ratio of bases of a cylinder and a cone are in the ratio 3: Volume of cylinder and cone are in the ratio 9: then their heights are in the ratio?....
QA->The total number of members in the Legislative Council of a State shall not exceed __ of the total number of members in the State Legislative Assembly.?....
QA->A liquid will not wet the surface of solid if the angle of contact is which angle?....
QA->‘We shall either free India or die in the attempt; We shall not live to see the perpetuation of our slavery’ Mahathma Gandhi said these words in connection with?....
QA->How much the time gap between two sessions of the Parliament should not exceed?....
MCQ->The slenderness ratio of single angle discontinuous struts conmected by a single rivet or bolt, shall not exceed....
MCQ->If P1 is the initial tension due to tightening up the bolt and P2 is the external load on the bolt, then the resultant load (P) on a bolt may be obtained by using the relation (where a = Ratio of elasticity of connected parts to the elasticity of bolt)....
MCQ->The following observation relate to designing of laced column : 1. Single lacing systems on opposite planes shall preferably be in the same direction so that one is the shadow of the other. 2. Lacing bar should only be a flat. 3. The slenderness ratio of the lacing bars for compression shall not exceed 180. 4. Laced compression members are to be provided with tie plates of ends. Of these observations :....
MCQ->The distance measured along one rivet line from the centre of a rivet to the centre of adjoining rivet on an adjacent parallel rivet line, is called....
MCQ->If the area of cross-section of a single angle discontinuous strut is 30 cm2 and allowable working stress corresponding to its slenderness ratio is 625 kg/cm2, the safe load carrying capacity of the member, is....
×
×
Type The Issue
×
Your Marks
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...
Privacy
|
Terms And Conditions
Question ANSWER With Solution