Question Set

1. A 30 m steel tape was standardised at 20°C measurements of distances were taken as 15°C. If the coefficient of linear expansion of the material of the tape were 0.00, 00112 degree centigrade, then the error, due to temperature, per tape length would be





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Coefficient of linear expansion always …….. with the increase in temperature?....
QA->Chemical mastication is operational after (deg. Centigrade)....
QA->Compared to the distances between the planets of our solar system, the distances between stars are usually?....
QA->A train of length 150 meters took 8 seconds to cross a bridge of length 250 meters. Time taken by the train to cross a telephone post is....
QA->A photo sensitive material would emit electrons, if excited by photons beyond a threshold. To overcome the threshold, one would increase?....
MCQ->A 30 m steel tape was standardised at 20°C measurements of distances were taken as 15°C. If the coefficient of linear expansion of the material of the tape were 0.00, 00112 degree centigrade, then the error, due to temperature, per tape length would be....
MCQ->Consider the following assumptions of Bowditch method : 1. Angular measurements are more precise than linear measurements. 2. Linear measurements are more prescise than angular measurements. 3. Erros in linear measurements are proportional to L . 4. Correction to latitude or departure of any side = Total error in L (or D) x Length of that side / Perimeter of traverse. Which of these statements are correct ?....
MCQ->According to IS: 800-1962, the coefficient of expansion of steel per degree centigrade per unit length, is taken as....
MCQ->As per IS : 800-1982, the coefficient of expansion for steel per degree centigrade per unit length, is....
MCQ->A standard steel tape of length 30 m and cross-section 15 x 1.0 mm was standardised at 25°C and at 30 kg pull. While measuring a base line at the same temperature, the pull applied was 40 kg. If the modulus of elasticity of steel tape is 2.2 x 106 kg/cm2, the correction to be applied is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution