Question Set

1. A standard steel tape of length 30 m and cross-section 15 x 1.0 mm was standardised at 25°C and at 30 kg pull. While measuring a base line at the same temperature, the pull applied was 40 kg. If the modulus of elasticity of steel tape is 2.2 x 106 kg/cm2, the correction to be applied is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A train of length 150 meters took 8 seconds to cross a bridge of length 250 meters. Time taken by the train to cross a telephone post is....
QA->What is the SI unit of Young’s modulus of elasticity?....
QA->A, B and C start at the same time in the same direction to run around a circular stadium. A completes a round in 252 seconds, B in 308 seconds and c in 198 seconds, all starting at the same point. After what time will they again at the starting point ?....
QA->If a graph is plotted taking the temperature in Fahrenheit along the Y-axis and the corresponding temperature in Celsius along X- axis it will be the straight line?....
QA->A line that connects points on a map that have the same temperature is ______?....
MCQ->A standard steel tape of length 30 m and cross-section 15 x 1.0 mm was standardised at 25°C and at 30 kg pull. While measuring a base line at the same temperature, the pull applied was 40 kg. If the modulus of elasticity of steel tape is 2.2 x 106 kg/cm2, the correction to be applied is....
MCQ->ABC is rigid bar. It is hinged at A and suspended at B and C by two wires BD and CE made of copper and steel respectively, as shown in the given figure. The bar carries load of 1t at F, mid-way between B and C. Given Ac = 4 cm2, A = 2 cm2, Ec = 1 x 106 kg/cm2, Es = 2 x 106 kg/cm2. Ps is the force in the steel wire and Pc is the force in the copper wire, the ratio Pc/Ps will be

....
MCQ->A steel bar of 2 m length is fixed at both ends at 20°C. The coefficient of thermal expansion is 11 x 10-6/°C and the modulus of the elasticity is 2 x 106 kg/cm2. If the temperature is changed to 18°C, then the bar will be experience a stress of....
MCQ->A 30 m steel tape was standardised at 20°C measurements of distances were taken as 15°C. If the coefficient of linear expansion of the material of the tape were 0.00, 00112 degree centigrade, then the error, due to temperature, per tape length would be....
MCQ->If F is the pull applied at the ends of tape in kg, l is the length of tape between end marks in metres, w is the weight of the tape in kg per metre run, then sag correction....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution