Question Set

1. What is the ratio of the permissible bearing stress in power driven shop rivets relative to the yield stress of mild steel ?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The ratio of bases of a cylinder and a cone are in the ratio 3: Volume of cylinder and cone are in the ratio 9: then their heights are in the ratio?....
QA->Yield stress is shown by....
QA->Stainless Steel ഉണ്ടാക്കാൻ Steel ൻ്റെകുടെ ചേർക്കുന്ന ലോഹം....
QA->Which steel firm has won the Prime Minister’s trophy for ‘Best Performing Integrated Steel Plant’ in 2015-16?....
QA->In a mixture of 35 litres, the ratio of milk and water is 5 : Another 5 litres of milk is added to the mixture. The ratio of milk and water in the new mixture is—....
MCQ->What is the ratio of the permissible bearing stress in power driven shop rivets relative to the yield stress of mild steel ?....
MCQ->In February 2014, the number of paperback editions sold by shop D was 5% more than the same sold by the same shop in the previous month. The number of paperback editions sold in February 2014 by shop D constituted 75% of the total number of books sold by shop D in February 2014. What was the total number of books sold in February 2014 by shop D....
MCQ->A mild steel specimen is under uni-axial tensile stress. Young's modulus and yield stress for mild steel are 2 x 105 MPa and 250 MPa respectively. The maximum amount of strain energy per unit volume that can be stored in this speciment without permanent set, is....
MCQ->Statement: Large number of people have become critically ill after consuming spurious liquor from a local shop. Courses of Action: I. The Government should immediately close down all the shops selling liquor till the stocks are tested for presence of toxicity. II. The owner of the liquor shop should be asked to leave the town and open a shop elsewhere. III. The owner of the liquor shop should immediately be arrested and tried for criminal negligence.

....
MCQ->Consider the following assumptions : 1. The shearing stress in all the rivets is uniform 2. The bearing stress is not uniform 3. Bending of rivets can be neglected The assumptions made while designing a riveted joint would include....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution