Question Set

1. What is the volume of a 6 m deep tank having rectangular shaped top 6 m x 4 m and botton 4 m x 2 m (computed through the use of prismoidal formula) ?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Who said ‘Climbing to the top demands strength; whether it is to the top of Mount Everest or to the top of your career’?....
QA->Compound having the same molecular formula but different structural formula are called?....
QA->Volume of a sphere is c.c. What is the volume of a sphere having half its radius?....
QA->The angle of elevation of the top of a hill at the foot of a tower is 60° and the angle of elevation of the top of the tower from the foot of the hill is 30°. If the tower is 50 m high, the height of the hill is—....
QA->Why is a water tank appears shallower when it is viewed from top?....
MCQ->What is the volume of a 6 m deep tank having rectangular shaped top 6 m x 4 m and botton 4 m x 2 m (computed through the use of prismoidal formula) ?....
MCQ->A water tank has one inlet, A and one outlet, B. A takes 5 hours to fill the empty tank, when B is not open and B takes 8 hours to empty the full tank, if the tank is three fifth full, how much time will it take to fill the tank completely when both A and B are opened simultaneously ?(in hours)....
MCQ->Water is entering a storage tank at a temperature T0 and flow rate Q0 and leaving at a flow rate Q and temperature T. There are negligible heat losses in the tank. The area of cross-section of the tank is A0. The model that describes the dynamic variation of temperature of water in the tank with time is given as : ....
MCQ->Water is to be pumped at the rate of 0.025 m3/s from a 4 m deep ground level tank to an overhead tank. The difference in levels of the full tank levels of these tanks is 16 m. What is the approximate power required for operating a 65% efficient centrifugal pump ?....
MCQ->Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter)....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution