Question Set

1. A mild steel flat of width 120 mm and thickness 10 mm is bent into an arc of a circle of radius 10 m by applying a pure moment 'M' If E is 2 x 105 N/mm2, then the magnitude of the pure moment 'M' will be





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A steel wire when bent in the form of a square encloses an area of 121 sq. cm. If the same wire is bent into the form of a circle, the area of the circle is—....
QA->Post and Telegraph circle got bifuricated and Kerala Postal Circle came into existence in?....
QA->In a certain code, "FOP" stands for "OLD IS GOLD", POT stands for "GOLD IS PURE" and POM stands for GOLD IS COSTLY. Then how will "PURE OLD GOLD IS COSTLY" be written?....
QA->A man is facing East, then the turns left and goes 10 m, then turns right and goes 5 m, then goes 5 m to the South and from there 5 m to West. In which direction is he, from his original place ?....
QA->John started from his home and walked 12 km.Then he took a right turn and walked 4 km.Then again,he took a right turn and walked 8 km and finally took another right turn and walked 1 km.How far is he from his home now?....
MCQ->A mild steel flat of width 120 mm and thickness 10 mm is bent into an arc of a circle of radius 10 m by applying a pure moment 'M' If E is 2 x 105 N/mm2, then the magnitude of the pure moment 'M' will be....
MCQ->A beam has the same section throughout its length with I = 1 x 108mm4, It is subjected to a uniform B.M. = 40 kNm. E = 2 x 105 N/mm2, What is the radius of curvature of the circle into which the beam will bend in the form of an arc of a circle ?....
MCQ->A compound bar consists of two bars of equal length. Steel bar cross-section is 3500 mm2 and that of brass bar is 3000 mm2. These are subjected to a compressive load 100,000 N. If Eb = 0.2 MN/mm2 and Eb = 0.1 MN/mm2, the stresses developed are:....
MCQ->A mild steel bar of square cross-section 40 mm x 40 mm is 400 mm long. It is subjected to a longitudinal tensile stress of 440 N/mm2 and lateral compressive stress is 200 N/mm2 in perpendicular directions. E = 2 x 10-5 N/mm2, μ = 0.3. What is the approximate elongation of tht bar in the longitudinal direction ?....
MCQ->If RADIUS = 3.0 the result of the following FORTRAN 77 program will be

REAL RADIUS, CAREA, SAREA, RATIO
PI
PI = 3.1416
READ , RADIUS CAREA = PI RADIUS RADIUS
SAREA = 2 RADIUS RADIUS
RATIO = CAREA/SAREA....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution