Question Set

1. A beam has the same section throughout its length with I = 1 x 108mm4, It is subjected to a uniform B.M. = 40 kNm. E = 2 x 105 N/mm2, What is the radius of curvature of the circle into which the beam will bend in the form of an arc of a circle ?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A steel wire when bent in the form of a square encloses an area of 121 sq. cm. If the same wire is bent into the form of a circle, the area of the circle is—....
QA->The radius of a wire is decreased to its one third and if the volume remains the same how many times the length will increase?....
QA->A train moving with uniform speed passed a bridge of length 2000 metres in 2 ½ minutes.It took ½ minutes to pass a telephone post.What is the length of the train in metres?....
QA->Geethu purchased 12 pencils and 8 pens for Rs.Neethu purchased 5 pencils and 10 pens for Rs.105,From the same trader,at the same rate,What is the price of one pencil?....
QA->Which is the planet its length of its day and the tilt of its axis are almost identical to those of the earth?....
MCQ->A beam has the same section throughout its length with I = 1 x 108mm4, It is subjected to a uniform B.M. = 40 kNm. E = 2 x 105 N/mm2, What is the radius of curvature of the circle into which the beam will bend in the form of an arc of a circle ?....
MCQ->A compound bar consists of two bars of equal length. Steel bar cross-section is 3500 mm2 and that of brass bar is 3000 mm2. These are subjected to a compressive load 100,000 N. If Eb = 0.2 MN/mm2 and Eb = 0.1 MN/mm2, the stresses developed are:....
MCQ->A mild steel flat of width 120 mm and thickness 10 mm is bent into an arc of a circle of radius 10 m by applying a pure moment 'M' If E is 2 x 105 N/mm2, then the magnitude of the pure moment 'M' will be....
MCQ->A mild steel bar of square cross-section 40 mm x 40 mm is 400 mm long. It is subjected to a longitudinal tensile stress of 440 N/mm2 and lateral compressive stress is 200 N/mm2 in perpendicular directions. E = 2 x 10-5 N/mm2, μ = 0.3. What is the approximate elongation of tht bar in the longitudinal direction ?....
MCQ->A shaft is subjected to a maximum bending stress of 80 N/mm2 and maximum shearing stress equal to 30 N/mm2 at a particular section. If the yield point in tension of the material is 280 N/mm2 and the maximum shear stress theory of failure is used, then the factor of safety obtained will be....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution