Question Set

1. The kinetic energy in Nm of a circular disc of 20 m diameter and 10 cm thick, of material weighing 100 kg/m3, rotating above an axis through its centre at right angles to its place and making 2000 rpm is



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A circular disc of copper has a symmetrical hole at its center. The disc is uniformly heated. The diameter of the hole will?....
QA->If a rotating body spins on its axis, its motion is called?....
QA->Which spacecraft found that the rings of the golden giant Saturn are composed of thousands of rippling spiralling bands of Icy rock and dust, just 200 m thick and 270km in diameter?....
QA->John started from his home and walked 12 km.Then he took a right turn and walked 4 km.Then again,he took a right turn and walked 8 km and finally took another right turn and walked 1 km.How far is he from his home now?....
QA->Capability of rotating objects around a fixed axis is called?....
MCQ->The kinetic energy in Nm of a circular disc of 20 m diameter and 10 cm thick, of material weighing 100 kg/m3, rotating above an axis through its centre at right angles to its place and making 2000 rpm is....
MCQ->According to parallel axis theorem, the moment of inertia of a section about an axis parallel to the axis through centre of gravity (i.e. IP) is given by(where, A = Area of the section, IG = Moment of inertia of the section about an axis passing through its C.G., and h = Distance between C.G. and the parallel axis.)....
MCQ->A disc is a spinning with an angular velocity ω rad/s about the axis of spin. The couple applied to the disc causing precession will be (where I = Mass moment of inertia of the disc, and ωP = Angular velocity of precession of the axis of spin)....
MCQ->A shaft has an attached disc at the centre of its length. The disc has its centre of gravity located at a distance of 2 mm from the axis of the shaft. When the shaft is allowed to vibrate in its natural bow-shaped mode, it has a frequency of vibration of 10 rad/s. When the shaft is rotated at 300 r.p.m., it will whirl with a radius of....
MCQ->A circular hole of 50 mm diameter is cut out from a circular disc of 100 mm diameter as shown in the below figure. The centre of gravity of the section will lie ....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution