Question Set

1. After displaying the directory of a floppy disk, a different floppy is inserted into the drive. The contents of the original floppy continue to display regardless of the director requests on the other floppies placed in the drive. You remove the drive in question and install it into your test system, and it does not exhibit the problem. You should next replace the:




Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Correct sentences among the following are: ) The tea is too hot that I cannot drink (2) Work hard, lest you should miss the chance (3) Unless you study well, you will fail (4) Unless you study well, you will pass....
QA->If you have a Power point show you created and want to send using E-mail to another teacher you can add the show to your E-mail message as an______....
QA->Who can remove a member of a Co-operative Socitey who become disqualified to continue as a member....
QA->Which compound does not give a positive test in Lassaigne’s test for nitrogen?....
QA->Two trains are 2 km apart and their lengths are 200 m and 300 m. They are approaching towards each other with a speed of 20 m/s and 30 m/s respectivety. after how much time they cross each other....
MCQ->After displaying the directory of a floppy disk, a different floppy is inserted into the drive. The contents of the original floppy continue to display regardless of the director requests on the other floppies placed in the drive. You remove the drive in question and install it into your test system, and it does not exhibit the problem. You should next replace the:....
MCQ->You install your boot volume on volume C on your Windows 2000 Server computer. You mirror volume C on dynamic Disk 1. Two years later, during routine server maintenance, you open Disk Management and find that the status of volume C is Failed Redundancy. The status of Disk 1 is Missing. You attempt to reactivate Disk 1, but the status of volume C does not return to Healthy. What should you do next?....
MCQ->You install the Routing and Remote Access service on a Windows 2000 Server computer in your network. Your network is not directly connected to the Internet and uses the private IP address range 192.168.0.0. When you use Routing and Remote Access to dial in to the server, your computer connects successfully, but you are unable to access any resources. When you try to piiig servers by using their IP addresses, you receive the following message: "Request timed out." When you run the ipconfig command, it shows that your dial-up connection has been given the IP address 169.254.75.182. What should you do to resolve the problem?....
MCQ->You are the administrator of Windows 2000 Server computer. Your computer has a span volume that consists of areas on three physical hard disks on the server. The three disks support hot swapping. You regularly backup the span volume by using windows backup. One of the disk fail, you replace the disk with a new un-partitioned disk. You want to recover the span volume and disk data as soon as possible. What should you do?....
MCQ->You are configuring a Windows 2000 Server computer as a Routing and Remote Access server for a Branch office. You discover that an incorrect driver was installed during the installation of the modem. You attempt to remove the modem by using Phone and Modem Options in Control Panel. After each attempt to remove the modem by using this method, the computer stops responding. You restart the computer again. You must install the correct driver for the modem as quickly as possible. What should you do?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution