1. Which Motherboard form factor uses one 20 pin connector
2. A hard disk is divided into tracks which are further subdivided into:
3. A wrist grounding strap contains which of the following:
4. Which standard govern parallel communications?
5. In laser printer technology, what happens during the conditioning stage?
6. What product is used to clean smudged keys on a keyboard?
7. ESD would cause the most damage to which component?
8. To view any currently running Terminate Stay Resident (TSR's) programs you could type:
9. Which type of system board is the MOST likely candidate for processor upgrading if you want maximum performance and future compatibility?
10. Suppose that you have a the maintenance package identifies several possible field replaceable units (FRUs) that will resolve the problem. What should you do after turning the power off?
11. Most PCs give a single beep on bootup to indicate they are ok hardware wise. You boot your PC and don't get a beep. What should you check first?
12. Which peripheral port provides the FASTEST throughput to laser printers?
13. The mouse pointer moves erratically, what is the possible cause? The mouse
14. Voltage is measured:
15. Your customer tells you the print quality of their dot matrix printer is light then dark. Which of the following could cause the problem.
16. The 34-pin connection on an I/O card is for?
17. The terms "red book", "yellow book", and "orange book" refer to:
18. On the 16-bit ISA bus, IRQ2 is elevated to which higher level Interrupt?
19. What beep codes could indicate a system board or power supply failure?
20. Which part of the laser printer should NOT be exposed to sunlight?
21. After doing a low-level format, what would be the next step in configuring the hard drive in a system?
22. Resistance is measured in ?
23. What command is used to reset a MODEM when using the "AT Command Set"?
24. When installing a SCSI CD-ROM drive, you must set the CD-ROM SCSI adapter to: