Question Set

1. The ‘copy’command saves the content temporarily to the:





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Which can be used for checking inflation temporarily?....
QA->Copy(n)....
QA->Which option is selected, MS- Word will print a complete set of the first copy, then the second set and so on. ?....
QA->The process of taking out more than one copy with the help of carbon paper is called.................
QA->To copy the formatting of a selection to a specific location, the shortcut key is:....
MCQ->The ‘copy’command saves the content temporarily to the:....
MCQ->You have your laptop directly connected into a router's Ethernet port. Which of the following are among the requirements for the copy flash tftp command to be successful? TFTP server software must be running on the router. TFTP server software must be running on your laptop. The Ethernet cable connecting the laptop directly into the router's Ethernet port must be a straight-through cable. The laptop must be on the same subnet as the router's Ethernet interface. The copy flash tftp command must be supplied the IP address of the laptop.....
MCQ->It takes 6 hours to dry a wet solid from 50% moisture content to the critical moisture content of 15%. How much longer it will take to dry the solid to 10% moisture content, under the same drying conditions? (The equilibrium moisture content of the solid is 5%).....
MCQ->In a laboratory test run, the rate of drying was found to be 0.5 x 10-3 kg/m2.s, when the moisture content reduced from 0.4 to 0.1 on dry basis. The critical moisture content of the material is 0.08 on a dry basis. A tray dryer is used to dry 100 kg (dry basis) of the same material under identical conditions. The surface area of the material is 0.04 m2/kg of dry solid. The time required (in seconds) to reduce the moisture content of the solids from 0.3 to 0.2 (dry basis) is....
MCQ->A solid is being dried in the linear drying rate regime from moisture content Xo to XF. The drying rate is zero at X = 0 and the critical moisture content is the same as the initial moisture Xo. The drying time for M = (Ls/ARc) is (where, L = total mass of dry solid, A = total surface area for drying Rc = Constant maximum drying rate per unit area X = moisture content (in mass of water/mass of dry solids))....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution