Question Set

1. It takes an op-amp 22 s to change its output from –15 V to +15 V. Determine the slew rate.





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->At his usual rowing rate, Rahul can travel 12 miles downstream in a certain river in 6 hrs less than it takes him to travel the same distance upstream. But if he could double his usual rowing rate for this 24 mile round trip, the downstream 12 miles would then take only one hour less than the upstream 12 miles. What is the speed of the current in miles per hour?....
QA->At his usual rowing rate, Ram can travel 12 miles downstream in a certain river in 6 hrs less than it takes him to travel the same distance upstream. But if he could double his usual rowing rate for this 24 mile round trip, the downstream 12 miles would then take only one hour less than the upstream 12 miles. What is the speed of the current in miles per hour?....
QA->The process of sudden heritable change in a gene due to change in its composition is called ?....
QA->The incapability of a body to change by itself its state of rest or its state of uniform motion along a straight line?....
QA->The steady state from which no spontaneous change takes place is called?....
MCQ->It takes an op-amp 22 s to change its output from –15 V to +15 V. Determine the slew rate.....
MCQ->It is suspected that the comparator in the figure given below has a problem. The inputs are activated in the table shown below and the corresponding outputs noted. What is most likely wrong with the circuit? For P0 – P3 = 1 and Q0 – Q3 = 0, P > Q = 1, P = Q = 1, P < Q = 0 For P0 – P3 = 0 and Q0 – Q3 = 1, P > Q = 0, P = Q = 1, P < Q = 1 For P0 – P3 = 1 and Q0 – Q3 = 1, P > Q = 0, P = Q = 1, P < Q = 0

....
MCQ->Assertion (A): A sine wave with slew rate distortion looks rectangularReason (R): The maximum rate of output voltage change is called slew rate

....
MCQ->It takes 4 s for the output voltage of an op-amp to rise from –14 V to +14 V. The slew rate of this op-amp is 3.5 V/s.....
MCQ->What will be the output of the program? #include<stdio.h> int main() { int i=4, j=-1, k=0, w, x, y, z; w = i || j || k; x = i && j && k; y = i || j &&k; z = i && j || k; printf("%d, %d, %d, %d\n", w, x, y, z); return 0; }....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution