Question Set

1. It takes 4 s for the output voltage of an op-amp to rise from –14 V to +14 V. The slew rate of this op-amp is 3.5 V/s.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->At his usual rowing rate, Rahul can travel 12 miles downstream in a certain river in 6 hrs less than it takes him to travel the same distance upstream. But if he could double his usual rowing rate for this 24 mile round trip, the downstream 12 miles would then take only one hour less than the upstream 12 miles. What is the speed of the current in miles per hour?....
QA->At his usual rowing rate, Ram can travel 12 miles downstream in a certain river in 6 hrs less than it takes him to travel the same distance upstream. But if he could double his usual rowing rate for this 24 mile round trip, the downstream 12 miles would then take only one hour less than the upstream 12 miles. What is the speed of the current in miles per hour?....
QA->The device used for converting current from a lower voltage to a higher voltage is known as?....
QA->are based on the principle that the rate of water absorption is essentially equal to the rate of water loss?....
QA->The Employees’ Provident Fund Organisation (EPFO) raised the interest rate on Employees’ Provident Fund (EPF) for 2018-19. What is the new interests rate?....
MCQ->It takes 4 s for the output voltage of an op-amp to rise from –14 V to +14 V. The slew rate of this op-amp is 3.5 V/s.....
MCQ->It is suspected that the comparator in the figure given below has a problem. The inputs are activated in the table shown below and the corresponding outputs noted. What is most likely wrong with the circuit? For P0 – P3 = 1 and Q0 – Q3 = 0, P > Q = 1, P = Q = 1, P < Q = 0 For P0 – P3 = 0 and Q0 – Q3 = 1, P > Q = 0, P = Q = 1, P < Q = 1 For P0 – P3 = 1 and Q0 – Q3 = 1, P > Q = 0, P = Q = 1, P < Q = 0

....
MCQ->Assertion (A): A sine wave with slew rate distortion looks rectangularReason (R): The maximum rate of output voltage change is called slew rate

....
MCQ->It takes an op-amp 22 s to change its output from –15 V to +15 V. Determine the slew rate.....
MCQ->Consider 49 cascaded amplifiers having individual rise time as 2 n sec. 3 n sec. ... 50 n sec. The input waveform rise time is 1 n sec. Then the output signal rise time is given time by (Assume output signal rise time is measured within 10 percent range of the final output signal.)....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution