How long would it take the capacitor in the given circuit to completely discharge if the switch was in position 2?p> ?->(Show Answer!)

Question Set

1. How long would it take the capacitor in the given circuit to completely discharge if the switch was in position 2?

Show Similar Question And Answers

QA->A statement followed by two assumptions I and II is given. You have to consider the statement to be true even if it seems to be at variance from commonly known facts. You are to decide which of the given assumptions can definitely be drawn from the given statement. Indicate which one of the four given alternatives is correct ? Statement : If more encouragement is given to Sports, Indians will win more gold medals at the Olympic Games. Assumptions : I. Indians do not win gold medals. II. More enc....

QA->A train 110ms long passes a telegraph pole in 3 seconds. How long will it take to cross railway platform 165 ms long....

QA->How long does a train 110 metres long running at a speed of 36 km/hour take to cross a bridge of 132 metres in length?....

QA->At the time of short-circuit; what will be the current in the circuit?....

QA->At the time of short-circuit, what will be the current in the circuit?....

MCQ->How long would it take the capacitor in the given circuit to completely discharge if the switch was in position 2?

MCQ->You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy? Switch(config-if)# ip access-group 10 Switch(config-if)# switchport port-security maximum 1 Switch(config)# access-list 10 permit ip host 1 Switch(config-if)# switchport port-security violation shutdown Switch(config)# mac-address-table secure....

MCQ->How long would it take the capacitor in the given circuit to completely charge if the switch was in position 1?

MCQ->In the given circuit, the switch has been in position 1 for quite a long time. At t = 0 the switch is moved to position 2. At this position what is the time constant? ....

MCQ->Which of the following sentences are correct about a switch loop in a C program? 1: switch is useful when we wish to check the value of variable against a particular set of values. 2: switch is useful when we wish to check whether a value falls in different ranges. 3: Compiler implements a jump table for cases used in switch. 4: It is not necessary to use a break in every switch statement.....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution