Question Set

1. When the ac base voltage in a CE amplifier circuit is too high, the ac emitter current is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 01 Jun 2017 11.43 pm
    A high signal causes distortion because v-i characteristics of BJT is non-linear.
Show Similar Question And Answers
QA->The device used for converting current from a lower voltage to a higher voltage is known as?....
QA->At the time of short-circuit; what will be the current in the circuit?....
QA->At the time of short-circuit, what will be the current in the circuit?....
QA->Speed of a swimmer when moving in the direction perpendicular to the direction of the current is 16 km/h, speed of the current is 3 km/h. So the speed of the swimmer against the current will be (in km/h):....
QA->A man who can swim 48 m/minute in still water. He swims 200 m against the current and 200 m with the current. If the difference between those two times is 10 minutes, what is the speed of the current?....
MCQ->What will be the output of the following program? #include<iostream.h> class Base { int x, y; public: Base() { x = y = 0; } Base(int xx) { x = xx; } Base(int p, int q = 10) { x = p + q; y = q; } void Display(void) { cout<< x << " " << y << endl; } }objDefault(1, 1); class Derived: public Base { Base obj; public: Derived(int xx, int yy): Base(xx, xx + 1) { } Derived(Base objB = objDefault) { } }; int main() { Derived objD(5, 3); Derived ptrD = new Derived(objD); ptrD->Display(); delete ptrD; return 0; }....
MCQ->When the ac base voltage in a CE amplifier circuit is too high, the ac emitter current is....
MCQ->Which of the following conditions must be satisfied for a transistor to remain under saturation? Its collector to base junction should be under forward bias.Its collector to base junction should be under reverse bias.Its emitter to base junction should be under reverse bias.Its emitter to base junction should be under forward bias. Select the correct answer from the codes given below:....
MCQ->The voltage measured from the collector to the emitter is the sum of the voltage base-emitter plus the voltage collector-base.....
MCQ->The voltage measured from the collector to the emitter is the sum of the base-emitter voltage plus the collector-base voltage.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution