Question Set

1. A bridge rectifier circuit has a dc load current of 10 mA and a filter capacitance of 1000 μF. The peak to peak ripple voltage is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 01 Jun 2017 11.43 pm
    Peak to peak ripple voltage = .
Show Similar Question And Answers
QA->The device used for converting current from a lower voltage to a higher voltage is known as?....
QA->At the time of short-circuit; what will be the current in the circuit?....
QA->At the time of short-circuit, what will be the current in the circuit?....
QA->A man who can swim 48 m/minute in still water. He swims 200 m against the current and 200 m with the current. If the difference between those two times is 10 minutes, what is the speed of the current?....
QA->A man who can swim 48 m/minute in still water. He swims 200 m against the current and 200 m with the current. If the difference between those two times is 10 minutes, what is the speed of the current?....
MCQ->A bridge rectifier circuit has a dc load current of 10 mA and a filter capacitance of 1000 μF. The peak to peak ripple voltage is....
MCQ->Consider the following rectifier circuits : half-wave rectifier without filterfull-wave rectifier without filterfull-wave rectifier with series inductance filterfull-wave rectifier with capacitance filter. The sequence of these rectifier circuits in decreasing order of their ripple factor is....
MCQ->Assertion (A): A rectifier with inductor filter is more efficient for high load current.Reason (R): In rectifier with inductor filter we can use a larger choke to reduce ripple, larger choke will have higher dc resistance which will result in lower dc output voltage for higher load current.

....
MCQ->Assertion (A): A half wave controlled rectifier has poorer efficiency and higher ripple factor than a full wave controlled rectifier.Reason (R): The use of a freewheeling diode in half wave controlled rectifier circuit improves the waveform of load current and circuit power factor.

....
MCQ->A rectifier circuit has load resistance R. It uses a capacitance filter having capacitance C. For low ripple in the output....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution