Question Set

1. In a self bias circuit for CE amplifier the collector supply voltage is made twice. The collector current will





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The device used for converting current from a lower voltage to a higher voltage is known as?....
QA->At the time of short-circuit; what will be the current in the circuit?....
QA->At the time of short-circuit, what will be the current in the circuit?....
QA->The supply voltage produced in India?....
QA->Speed of a swimmer when moving in the direction perpendicular to the direction of the current is 16 km/h, speed of the current is 3 km/h. So the speed of the swimmer against the current will be (in km/h):....
MCQ->In a self bias circuit for CE amplifier the collector supply voltage is made twice. The collector current will....
MCQ->Assertion (A): A fixed bias BJT circuit exhibits better performance as compared to a self bias BJT circuit.Reason (R): A fixed bias BJT circuit used less components as compared to a self bias BJT circuit.

....
MCQ->Assertion (A): A self bias circuit is the most commonly used bias circuit for bipolar junction transistorsReason (R): A self bias circuit limits the increase in collector or emitter current due to change in junction temperature.

....
MCQ->Which of the following conditions must be satisfied for a transistor to remain under saturation? Its collector to base junction should be under forward bias.Its collector to base junction should be under reverse bias.Its emitter to base junction should be under reverse bias.Its emitter to base junction should be under forward bias. Select the correct answer from the codes given below:....
MCQ->Discrete transistors T1 and T2 having maximum collector current rating of 0.75 amp are connected in parallel as shown in the figure, this combination is treated as a single transistor to carry a total current of 1 ampere, when biased with self bias circuit. When the circuit is switched on, T1 draws 0.55 amps and T2 draws 0.45 amps. If the supply is kept on continuously, ultimately it is very likely that ....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution