Question Set

1. How much is contributed by each bit in the code word of a PCM system under uniform and symmetric quantization to the signal to noise ratio?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The ratio of bases of a cylinder and a cone are in the ratio 3: Volume of cylinder and cone are in the ratio 9: then their heights are in the ratio?....
QA->Two trains are 2 km apart and their lengths are 200 m and 300 m. They are approaching towards each other with a speed of 20 m/s and 30 m/s respectivety. after how much time they cross each other....
QA->A word is given in capital letters. It is followed by four words. Out of these four words, three cannot be formed from the letters of the word in capital letters. Point out the word which can be formed from the letters of the given word in capital letters— ARCHITECTURE....
QA->The piece of hardware that converts your computer’s digital signal to an analog signal that can travel over telephone lines is called a–....
QA->There are 50 students in a class. In a class test 22 students get 25 marks each, 18 students get 30 marks each. Each of the remaining gets 16 marks. The average mark of the whole class is :....
MCQ->How much is contributed by each bit in the code word of a PCM system under uniform and symmetric quantization to the signal to noise ratio?....
MCQ->A certain 8 bit uniform quantization PCM system can accommodate a signal ranging from - 1 V to + V. The rms value of the signal is V . The signal to quantization noise ratio is:....
MCQ->For 10 bit PCM system, the signal to quantization noise ratio is 62 dB. If the number of bits is increased by 2, then the signal to quantization noise ratio will....
MCQ->A signal having uniformly distributed amplitude in the interval (- V to + V) is to be encoded using PCM with uniform quantization. The signal to quantization noise ratio is determined by....
MCQ->If N is the number of binary digits needed to assign individual binary code designations to the M quantization levels, the signal to quantization noise ratio S0/Nq in PCM is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution