Question Set

1. To have the multiprocessing capabilities of the 8086 microprocessor, the pin connected to the ground is




Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->PIN number എന്നതിൽ PIN ന്റെ പൂർണരൂപം....
QA->‘I have been touring different parts of the world. During these travels, I have had the good fortune to come into contact with several saints and maharshis. But I have frankly to admit that I have never come across one who is spiritually greater than Swami Sree Narayana Guru of Kerala” Whose words are these?....
QA->To make a notebook act as a desktop model, the notebook can be connected to a ………………….. which is connected to a monitor-and other devices.....
QA->An aeroplane is flying horizontally with a velocity of 600 km/h and at a height of 1960 m. When it is vertically at a point A on the ground a bomb is released from it. The bomb strikes the ground at point B. The distance AB is?....
QA->“During my travels throughout the world, I have had the good fortune to come in contact with several saints and maharishis... But I have frankly to admit that I have never come across one who is spiritually greater than Swami Narayana Guru or a person who is at par with him in spiritual attainment.” Who paid tribute in the above words after visiting Sree Narayana Guru?....
MCQ->To have the multiprocessing capabilities of the 8086 microprocessor, the pin connected to the ground is....
MCQ->Consider the following statements A total of about 1 million bytes can be directly accessed by 8086 microprocessor.The 8086 has thirteen 16 bit registers.The 8086 has eight flags.Compared to 8086, the 80286 provides a higher degree of memory protection. Of the above statements....
MCQ->To realize the full power of 8086 the pin of 8086 connected to ground is....
MCQ->The two links OA and OB are connected by a pin joint at O. If the link OA turns with angular velocity ω1 rad/s in the clockwise direction and the link OB turns with angular velocity ω2 rad/s in the clockwise direction, then the rubbing velocity at the pin joint O is (where r = Radius of the pin at O)....
MCQ->The two links OA and OB are connected by a pin joint at O. If the link OA turns with angular velocity ω1 rad/s in the clockwise direction and the link OB turns with angular velocity ω2 rad/s in the anti-clockwise direction, then the rubbing velocity at the pin joint O is (where r = Radius of the pin at O)....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution