Question Set

1. To realize the full power of 8086 the pin of 8086 connected to ground is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->In an examination A obtains 48 % of full marks and B obtains 33% of full marks. Together they get 567 marks. Find the full marks :....
QA->PIN number എന്നതിൽ PIN ന്റെ പൂർണരൂപം....
QA->To make a notebook act as a desktop model, the notebook can be connected to a ………………….. which is connected to a monitor-and other devices.....
QA->An aeroplane is flying horizontally with a velocity of 600 km/h and at a height of 1960 m. When it is vertically at a point A on the ground a bomb is released from it. The bomb strikes the ground at point B. The distance AB is?....
QA->The largests under ground power station in Kerala?....
MCQ->To realize the full power of 8086 the pin of 8086 connected to ground is....
MCQ->Consider the following statements A total of about 1 million bytes can be directly accessed by 8086 microprocessor.The 8086 has thirteen 16 bit registers.The 8086 has eight flags.Compared to 8086, the 80286 provides a higher degree of memory protection. Of the above statements....
MCQ->Which three statements are true about the operation of a full-duplex Ethernet network? There are no collisions in full-duplex mode. A dedicated switch port is required for each full-duplex node. Ethernet hub ports are preconfigured for full-duplex mode. In a full-duplex environment, the host network card must check for the availability of the network media before transmitting. The host network card and the switch port must be capable of operating in full-duplex mode.....
MCQ->The two links OA and OB are connected by a pin joint at O. If the link OA turns with angular velocity ω1 rad/s in the clockwise direction and the link OB turns with angular velocity ω2 rad/s in the clockwise direction, then the rubbing velocity at the pin joint O is (where r = Radius of the pin at O)....
MCQ->The two links OA and OB are connected by a pin joint at O. If the link OA turns with angular velocity ω1 rad/s in the clockwise direction and the link OB turns with angular velocity ω2 rad/s in the anti-clockwise direction, then the rubbing velocity at the pin joint O is (where r = Radius of the pin at O)....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution