Question Set

1. The charges between a hollow and solid metal spheres reside





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Which public sector bank recently announced to do away with charges on NEFT and RTGS transactions through internet and mobile banking from July 1?....
QA->A​ ​white​ ​solid’A’on​ ​heating​ ​gives​ ​off​ ​a​ ​gas​ ​which​ ​turns​ ​lime​ ​water milky.The​ residue​ ​is​ ​yellow​ ​when​ ​hot​ ​but​ ​turns​ ​white​ ​on​ ​cooling​ ​.The solid​ ​A​ ​is:....
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->A colloid formed between gas particles and liquid or solid particles?....
QA->Who developed the theory of universe through his book "Six Books concerning the Revolutions of the Heavenly Spheres" ?....
MCQ->The charges between a hollow and solid metal spheres reside....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->Two shafts 'A' and 'B' are made of same material. The shaft 'A' is solid and has diameter D. The shaft 'B' is hollow with outer diameter D and inner diameter D/2. The strength of hollow shaft in torsion is __________ as that of solid shaft.....
MCQ->The taxi charges in a city comprise of a fixed charge, together with the charge of the distance covered. For a journey of 16 km, the charges paid are Rs. 156 and for a journey of 24 km, the charges paid are Rs. 204. What will a person have to pay for travelling a distance of 30 km?....
MCQ->The ratio of strength of solid to hollow shaft,both having outside diameter D and hollow having inside diameter D/2 in torsion is:....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution