Question Set

1. When a magnetic circuit is compared with an electric circuit, the equivalent of the magnetic flux is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The unit of magnetic flux density?....
QA->Unit of magnetic flux?....
QA->At the time of short-circuit; what will be the current in the circuit?....
QA->At the time of short-circuit, what will be the current in the circuit?....
QA->Which is the instrument employed to change the voltage in an electric circuit?....
MCQ->When a magnetic circuit is compared with an electric circuit, the equivalent of the magnetic flux is....
MCQ->From a homogeneous and isotropic dielectric material of dielectric constant ∈r, a small volume element is taken out creating a cavity. The field can be kept homogeneous if Di. (i.e., electric flux density inside the cavity) and D0 (i.e., electric flux density outside the cavity) are such that....
MCQ->The flux density is ___ when the magnetic flux is 9 µWb and the cross-sectional area of the magnetic field is 5 × 10–3 m2.....
MCQ->After the magnetizing force has been removed, the ratio of the remaining magnetic flux to the saturated magnetic flux is called _____________.....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution