Question Set

1. In the circuit shown, in switch S is open for a long time and is closed at t = 0. The current i(t) for t ≥ 0+ is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 12.54 am
    i(f) = 0.5, i(i) = 0.75 i(t) = Vr + (ii - ij)e-1/p = 0.5 - 0.125e-1000t .
Show Similar Question And Answers
QA->At the time of short-circuit; what will be the current in the circuit?....
QA->At the time of short-circuit, what will be the current in the circuit?....
QA->A man who can swim 48 m/minute in still water. He swims 200 m against the current and 200 m with the current. If the difference between those two times is 10 minutes, what is the speed of the current?....
QA->A man who can swim 48 m/minute in still water. He swims 200 m against the current and 200 m with the current. If the difference between those two times is 10 minutes, what is the speed of the current?....
QA->ലോകത്ത് ഏറ്റവും കൂടുതൽ സി സി ടി വി (Closed- circuit television) ക്യാമറകൾ ഘടിപ്പിച്ച മെട്രോ നഗരം?....
MCQ->You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy? Switch(config-if)# ip access-group 10 Switch(config-if)# switchport port-security maximum 1 Switch(config)# access-list 10 permit ip host 1 Switch(config-if)# switchport port-security violation shutdown Switch(config)# mac-address-table secure....
MCQ->In the given circuit, the switch is open for a long time. At time t = 0, the switch is closed. What are the initial and final values of voltages across the inductor? ....
MCQ->In the circuit of figure the switch is open for a long time, At t = 0 the switch is closed. At t = 0+ the current supplied by battery is ....
MCQ->In the circuit shown, in switch S is open for a long time and is closed at t = 0. The current i(t) for t ≥ 0+ is ....
MCQ->In the circuit shown in the figure, steady-state was reached when the switch S was open. The switch was closed at t = 0. The initial value of the current through the capacitor 2 C is ....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution