Question Set

1. In figure, the switch is closed at t = 0. After some time i = 6A and rate of change of current was 4A/s. The value of inductor is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.07 am
    Steady state current = A. Therefore, i = (1 - e-3t/L) = 6A and From these equations L = 0.5H.
Show Similar Question And Answers
QA->A man who can swim 48 m/minute in still water. He swims 200 m against the current and 200 m with the current. If the difference between those two times is 10 minutes, what is the speed of the current?....
QA->A man who can swim 48 m/minute in still water. He swims 200 m against the current and 200 m with the current. If the difference between those two times is 10 minutes, what is the speed of the current?....
QA->Water evaporates at atmospheric pressure at a certain rate. If now the some water is placed in vaccum. The rate of evaporation?....
QA->Speed of a swimmer when moving in the direction perpendicular to the direction of the current is 16 km/h, speed of the current is 3 km/h. So the speed of the swimmer against the current will be (in km/h):....
QA->Speed of a speed-boat when moving in the direction perpendicular to the direction of the current is 25 km/h, speed of the current is 5 km/h. So, the speed of the boat against the current will be:....
MCQ->In figure, the switch is closed at t = 0. After some time i = 6A and rate of change of current was 4A/s. The value of inductor is ....
MCQ->A switch, a 220 resistor, and a 60 mH inductor are in series across a 20 V battery. What is the current through the inductor two time constants after the switch is closed?....
MCQ->You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy? Switch(config-if)# ip access-group 10 Switch(config-if)# switchport port-security maximum 1 Switch(config)# access-list 10 permit ip host 1 Switch(config-if)# switchport port-security violation shutdown Switch(config)# mac-address-table secure....
MCQ->In the circuit, S was initially open. At time t = 0, S is closed. When the current through the inductor is 6 A, the rate of change of current through the resistor is 6 A/s. The value of the inductor would be ....
MCQ->In figure, the switch is closed at t = 0 when current through inductor is 6 A, the rate of change of current through resistor is 6 A/s. The value of L is ....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution