Question Set

1. In figure, which value of ZL will cause maximum power to be transferred to the load?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.08 am
    As seen from ZL, the circuit impedance =
Show Similar Question And Answers
QA->The maximum speed at which data, can be transferred between two modes on a network is called:....
QA->Dog bite can cause rabies. Which other animal can also cause rabies?....
QA->Dog bite can cause rabies. Which other animals can also cause rabies?....
QA->Which gas has maximum calorific value?....
QA->Which gas has maximum colorific value?....
MCQ->In figure, which value of ZL will cause maximum power to be transferred to the load? ....
MCQ->Consider the following statements regarding a beam of uniform cross-section simply supported at its ends and carrying a concentrated load at one of its third points : 1. Its deflection under the load will be maximum. 2. The bending moment under the load will be maximum. 3. The deflection at the mid-point of the span will be maximum. 4. The slope at the nearer support will be maximum. Of these statements :....
MCQ->Consider the following statements pertaining to a pile group and a single pile at failure : 1. In loose and medium dense sands, the failure load per pile in a group will generally be greater than the failure load for a single pile. 2. In cohesive soils, the failure load per pile in a group will be greater than failure load for a single pile. 3. For piles driven in dense sands, the failure load per pile in a group is greater than the failure load for a single pile. 4. When the pile spacing is greater than 10 times the pile diameter, the failure loads per pile in a group and forly same in both sands and clays. Of these statements :....
MCQ->A voltage regulator with a no-load output dc voltage of 12 V is connected to a load with a resistance of 10 . If the load resistance decreases to 7.5 , the load voltage will decrease to 10.9 V. The load current will be ________, and the percent load regulation is ________.....
MCQ->The maximum power that can be transferred to the load is resistor RL from the voltage source in the figure is ....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution