1. An R-L series circuit is excited by a voltage v(t). The circuit was initially relaxed. Which of the following sources of v(t) would cause maximum current at t = 0+?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.08 am
    An impulse has very high rate of rise. Therefore, it causes maximum current.
Show Similar Question And Answers
QA->A photo sensitive material would emit electrons, if excited by photons beyond a threshold. To overcome the threshold, one would increase?....
QA->The device used for converting current from a lower voltage to a higher voltage is known as?....
QA->At the time of short-circuit; what will be the current in the circuit?....
QA->At the time of short-circuit, what will be the current in the circuit?....
QA->Speed of a swimmer when moving in the direction perpendicular to the direction of the current is 16 km/h, speed of the current is 3 km/h. So the speed of the swimmer against the current will be (in km/h):....
MCQ->An R-L series circuit is excited by a voltage v(t). The circuit was initially relaxed. Which of the following sources of v(t) would cause maximum current at t = 0+?....
MCQ->Consider the following statements: To draw a.c. equivalent circuit of a transistors, all d.c. sources are shorteda.c. sources are shortedd.c. sources are openeda.c. sources are connected to d.c. sources Which of the above statements is/are correct?....
MCQ->In the circuit shown in the given figure, switch k is closed at t = 0. The circuit was initially relaxed then which one of the following sources of v(t) will produce maximum current at t = 0+? ....
MCQ->A series RL circuit is initially relaxed. A step voltage is applied to the circuit. If t is the time constant of the circuit, the voltage across R and L will be same at time t equal to....
MCQ->A certain network has two ideal voltages sources and a large number of ideal resistances. The power consumed in one of the resistances is 4 W when either of two sources is active and the other source is active and the other source is short circuited. When both sources is short circuited.When both sources are active, the power consumed in the same resistor would be....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution