Question Set

1. Steady state conditions are considered to be achieved in R-L circuits at the end of __________ time constant.





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->An​ ​electrochemical​ ​cell​ ​which​ ​is​ ​used​ ​as​ ​a​ ​source​ ​of​ ​direct​ ​electrical current​ ​at​ constant​ ​voltage​ ​under​ ​standard​ ​conditions​ ​is​ ​called​ ​a:....
QA->For a body moving with constant speed in a horizontal circle; what remains constant?....
QA->For a body moving with constant speed in a horizontal circle, what remains constant?....
QA->സ്ഥിരാവസ്ഥാ സിദ്ധാന്തത്തിന്റെ (Steady State theory) ഉപജ്ഞാതാക്കൾ?....
QA->The steady state from which no spontaneous change takes place is called?....
MCQ->Steady state conditions are considered to be achieved in R-L circuits at the end of __________ time constant.....
MCQ->A long iron rod initially at a temperature of 20°C has one end dipped in boiling water (100°C) at time, t = 0. The curved surface of the rod is insulated so that heat conduction is one dimensional in the axial direction. The temperature at a distance 100 mm from the dipped end becomes 40°C at time, t = 200 s. The same temperature is achieved at a distance of 200 mm from the dipped end at time....
MCQ->Assertion (A): The steady state response, of a stable, linear, time invariant system, to sinusoidal input depends on initial conditions. Reason (R): Frequency response, in steady state, is obtained by replacing s in the transfer function by jω

....
MCQ->A 25 cm x 25 cm x 1 cm flat sheet weighing 1.2 kg initially was dried from both sides under constant drying rate conditions. It took 1500 seconds for the weight of the sheet to reduce to 1.05 kg. Another 1m x 1m x 1cm flat sheet of the same material is to be dried from one side only.Under the same constant drying rate conditions, the time required for drying (in seconds) from its initial weight of 19.2 kg to 17.6 kg is....
MCQ->Consider the following statements: For a master-slave J-K flip-flop, the toggle frequency is the maximum clock frequency at which the flip-flop will toggle reliably.the data input must precede the clock triggering edge transition time by time minimum time.the data input must remain fixed for a given time after, the clock triggering edge transition time for reliable operation.propagation delay time is equal to the rise time and fall time of the data. Which of the above statements is/are correct?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution