1. When iron rod is magnetised by the flowing through its coil, the polarities of its different points will be





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A coil of insulated wire bound on a rod shaped form made of solid iron is called?....
QA->Transformers, Microphones, Induction coil, Generators, Motors, Induction coil work on the principle of?....
QA->A charge of current in neighbouring coil will induce (contribute) a voltage (emf) in a coil is termed as?....
QA->When the radius of the T.G. coil is decreased; what does happen in its sensitiveness?....
QA->When the radius of the T.G. coil is decreased, what does happen in its sensitiveness?....
MCQ->When iron rod is magnetised by the flowing through its coil, the polarities of its different points will be ....
MCQ->The polarities of the magnetised iron rod of are ....
MCQ->A 600 mm long and 50 mm diameter rod of steel (E = 200 GPa, α = 12 x 10-6/°C) is attached at the ends to unyielding supports. When the temperature is 30°C there is no stress in the rod. After the temperature of the rod drops to - 20°C, the axial stress in the rod will be....
MCQ->The cylindrical cam C is held fixed while the rod AB and bearings E and F rotate about the vertical axis of the cam at a constant rate of = 4 rad/s. If the rod is free to slide through the bearings, determine the magnitudes of the velocity and acceleration of the guide D on the rod as a function of . The guide follows the groove in the cam, and the groove is defined by the equations r = 0.25 ft and z = (0.25 cos ) ft.....
MCQ->Consider the following statements regarding sources or error in a Q-meter: If a coil with resistance R is connected in direct measurement mode and if the residual resistance of Q-meter is 0.1 R, then the measure Q of the coil would be 1.1 times the actual Q.If the inductance to be measured is less than 0.1 mH, the error due to presence of residual inductance cannot be neglected.The presence of distributed capacitance in a coil modifies the effective Q of the coil. Which of the above statements are correct?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution