1. The hot resistance of a tungsten lame is about 12 times its cold resistance. Accordingly, the cold resistance of a 60 Ω, 120 V lamp is about __________ ohm.





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->.If three resistances 6 ohm,4 ohm and 3 ohm are connected in parallel,what will be the total resistance?....
QA->Father is aged three times more than his son Anil. After 8 years, he would be two and a half times of Anil"s age. After further 8 years, how many times would he be of Anil"s age?....
QA->Father is aged three times more than his son Ram . After 8 years, he would be two and a half times of Ram"s age. After further 8 years, how many times would he be of Ram"s age?....
QA->'Safety Lamp' or 'Davis Lamp' was invented by ?....
QA->Which element on adding to natural rubber makes it less sticky in hot weather and less hard in cold weather?....
MCQ->The hot resistance of a tungsten lame is about 12 times its cold resistance. Accordingly, the cold resistance of a 60 Ω, 120 V lamp is about __________ ohm.....
MCQ->A single element strain gauge bridge has two fixed resistances R1 and R1 of 120 Ω each and a variable resistance which gives full deflection at 120 Ω for zero strain and 120.6 Ω for straine e. If gauge factor is 2, strain e is....
MCQ->Match List-I with List-II and select the correct answer using the codes below A)Mediterranean 1.Temperate cycle is moderated by marine influence B)Marine west coast 2.Warm summers and cold winters with three months below freezing.Very large annual temperature range C)Dry mid latitude 3.Strong temperature cycle with large annual range.Warm summers to hot and cold winters to very cold D)Moist continental 4.Temperature range is moderate with warm to hot summers with cold winters A B C D....
MCQ->With 20 V applied, an 8-ohm resistor is in series with a lamp. When the lamp is removed, what voltage will be read across the lamp socket?....
MCQ->A 120 V lamp-dimming circuit is controlled by a rheostat and protected from excessive current by a 3 A fuse. To what minimum resistance value can the rheostat be set without blowing the fuse? Assume a lamp resistance of 20 ohms.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution