Question Set

1. If the ratio's of the corresponding forces acting at corresponding points are equal, then the model and the prototype are said to have.





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The ratio of bases of a cylinder and a cone are in the ratio 3: Volume of cylinder and cone are in the ratio 9: then their heights are in the ratio?....
QA->Five equal forces of 10 N each are applied at one point and all are lying in one plane. If angles between them are equal, the resultant of these forces wil be?....
QA->A man is facing East, then the turns left and goes 10 m, then turns right and goes 5 m, then goes 5 m to the South and from there 5 m to West. In which direction is he, from his original place ?....
QA->‘I have been touring different parts of the world. During these travels, I have had the good fortune to come into contact with several saints and maharshis. But I have frankly to admit that I have never come across one who is spiritually greater than Swami Sree Narayana Guru of Kerala” Whose words are these?....
QA->John started from his home and walked 12 km.Then he took a right turn and walked 4 km.Then again,he took a right turn and walked 8 km and finally took another right turn and walked 1 km.How far is he from his home now?....
MCQ->If the ratio's of the corresponding forces acting at corresponding points are equal, then the model and the prototype are said to have.....
MCQ->If the ratio of corresponding velocities at corresponding points are equal, then the model and the prototype are said to have dynamic similarity.....
MCQ->If the ratio of all the corresponding linear dimensions are equal, then the model and the prototype are said to have....
MCQ->A hydraulic model of a spillway is constructed with a scale 1 : 16. If the prototype discharge is 2048 cumec, then the corresponding discharge for which the model should be tested is....
MCQ->A hydraulic model of a spill way is constructed with a scale 1:If the prototype discharge is 3125 cumec,then the corresponding discharge for which the model should be tested is:....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution