Question Set

1. In diesel engines, the ignition takes place due to the heat produced in the engine cylinder at the end of compression.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->.Diesel cycle engines are also known as:....
QA->The ratio of bases of a cylinder and a cone are in the ratio 3: Volume of cylinder and cone are in the ratio 9: then their heights are in the ratio?....
QA->The ratio between the radius of the base and the height of a cylinder is 2 : If its volume is 1617 cm3, the total surface area of the cylinder is—....
QA->The minimum number of oil compression rings in an automobile engine is:....
QA->The common firing order of six cylinder engine is:....
MCQ->In diesel engines, the ignition takes place due to the heat produced in the engine cylinder at the end of compression.....
MCQ->The compression ratio in petrol engines is kept low as compared to diesel engines because higher compression ratio in petrol engines would lead to pre-ignition of fuel.....
MCQ->The engines in which the combustion of fuel takes place inside the engine cylinder are called internal combustion engines.....
MCQ->If p1, is the pressure of air entering the L.P. cylinder and p2 is the pressure of air leaving the L.P. cylinder (or intercooler pressure), then the ratio of cylinder diameters for a single acting, two stage reciprocating air compressor with complete intercooling is given by (where D1 = Dia. of L.P. cylinder, and D2 = Dia. of H.P. cylinder)....
MCQ->A noise produced in the cylinder of a diesel engine during combustion usually when the fuel oil has a low ignition quality is called:....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution