Question Set

1. In designing a sleeve coupling, outer diameter of the sleeve is taken as (where d = Diameter of the shaft)





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Which type of gear permits lower position of propeller shaft?....
QA->‘Wear one’s heart on one’s sleeve’ means :....
QA->In an automobile gear transmission the counter shaft drive gear is meshed with the gear on the:....
QA->The designing, building and flying of aircraft....
QA->The National Coir Training & Designing Centre is established at?....
MCQ->In designing a sleeve coupling, outer diameter of the sleeve is taken as (where d = Diameter of the shaft)....
MCQ->In designing a sleeve coupling, length of the sleeve is taken as (where d = Diameter of the shaft)....
MCQ->Two shafts 'A' and 'B' are made of same material. The shaft 'A' is solid and has diameter D. The shaft 'B' is hollow with outer diameter D and inner diameter D/2. The strength of hollow shaft in torsion is __________ as that of solid shaft.....
MCQ->Two shafts 'A' and 'B' have the same material. The shaft 'A' is solid of diameter 100 mm. The shaft 'B' is hollow with outer diameter 100 mm and inner diameter 50 mm. The torque transmitted by shaft 'B' is __________ as that of shaft 'A'.....
MCQ->In designing a flange coupling, the pitch circle diameter of bolts is taken as (where d = Diameter of the shaft)....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution