Question Set

1. The torque transmitted by a solid shaft of diameter (D) is (where τ = Maximum allowable shear stress)


Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The number of spherical bullets that can be made out of a solid cube of lead whose edge measures 44 cm, if the diameter of each bullet be 4 cm, is—....
QA->A​ ​white​ ​solid’A’on​ ​heating​ ​gives​ ​off​ ​a​ ​gas​ ​which​ ​turns​ ​lime​ ​water milky.The​ residue​ ​is​ ​yellow​ ​when​ ​hot​ ​but​ ​turns​ ​white​ ​on​ ​cooling​ ​.The solid​ ​A​ ​is:....
QA->The driven member of torque converter is known as:....
QA->Decrease of viscosity with increasing shear rate is known as....
QA->In a two roll mill the shear rate is adjusted by....
MCQ->The maximum shear stress in a solid shaft of circular cross-section having diameter d subjected to a torque T is τ. If the torque is increased by four times and the diameter of the shaft is increased by two times, the maximum shear stress in the shaft will be....
MCQ->The torque transmitted by a solid shaft of diameter (D) is (where τ = Maximum allowable shear stress)....
MCQ->Two shafts 'A' and 'B' have the same material. The shaft 'A' is solid of diameter 100 mm. The shaft 'B' is hollow with outer diameter 100 mm and inner diameter 50 mm. The torque transmitted by shaft 'B' is __________ as that of shaft 'A'.....
MCQ->A solid circular shaft transmits a torque of 80 Nm.If the allowable shear stress of the material is 150 MPa,assuming a factor of safety of 2,the minimum allowable design diameter in mm is:....
MCQ->Two shafts 'A' and 'B' are made of same material. The shaft 'A' is solid and has diameter D. The shaft 'B' is hollow with outer diameter D and inner diameter D/2. The strength of hollow shaft in torsion is __________ as that of solid shaft.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution