Question Set

1. The bending stress in a beam is __________ section modulus.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->ബീം (BEAM-Bigelow Expandable Activity Module) എന്നാൽ എന്ത് ? ....
QA->What is the SI unit of Young’s modulus of elasticity?....
QA->Which mirror is to be used to obtain a parallel beam of light from a small lamp?....
QA->Which mirror is to be used to obtain a parallel beam of light from a small lamp ?....
QA->The young’s modulus for perfectly rigid body is?....
MCQ->A simply supported beam of uniform cross-section is subjected to a maximum bending moment of 2.25 t.m. If it has rectangular cross-section with width 15 cm and depth 30 cm, then the maximum bending stress induced in the beam will be....
MCQ->If the section modulus of a beam is increased, the bending stress in the beam will....
MCQ->A square beam and a circular beam have the same length, same allowable stress and the same bending moment. The ratio of weights of the square beam to the circular beam is....
MCQ->The section modulus of a rectangular light beam 25 metres long is 12.500 cm3. The beam is simply supported at its ends and carries a longitudinal axial tensile load of 10 tonnes in addition to a point load of 4 tonnes at the centre. The maximum stress in the bottom most fibre at the mid span section, is....
MCQ->The design stress, which is more than the damaging stress, is the least unit stress that will render a member unfit for service before the end of its normal life. The design stress factor or factor of safety indicates the margin between design stress and the __________ stress.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution