Question Set

1. A square beam and a circular beam have the same length, same allowable stress and the same bending moment. The ratio of weights of the square beam to the circular beam is




Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Two satellite are moving in the same circular orbit around the earth they must have the same?....
QA->‘I have been touring different parts of the world. During these travels, I have had the good fortune to come into contact with several saints and maharshis. But I have frankly to admit that I have never come across one who is spiritually greater than Swami Sree Narayana Guru of Kerala” Whose words are these?....
QA->Which country has the highest average of road length on per thousand square kilometer area basis?....
QA->“During my travels throughout the world, I have had the good fortune to come in contact with several saints and maharishis... But I have frankly to admit that I have never come across one who is spiritually greater than Swami Narayana Guru or a person who is at par with him in spiritual attainment.” Who paid tribute in the above words after visiting Sree Narayana Guru?....
QA->The cause of fractional atomic weights of elements?....
MCQ->A square beam and a circular beam have the same length, same allowable stress and the same bending moment. The ratio of weights of the square beam to the circular beam is....
MCQ->The cross sections of the beams of equal length are a circle and a square whose permissible bending stress are same under same maximum bending. The ratio of their flexural weights is,....
MCQ->Consider the following statements : For an over-reinforced (singly reinforced) rectangular RC section. 1. the lever arm will be less than that for a balanced section. 2. the maximum stress developed by steel would equal the allowable stress in steel. 3. the maximum stress developed by concrete would equal allowable stress in concrete. Of these statements :....
MCQ->A solid circular shaft is subjected to a bending moment M and torque T. The ratio of maximum bending stress to the maximum shear stress is given by....
MCQ->If a circular shaft is subjected to a torque T and a bending moment 'M' the ratio of the maximum shear stress to the maximum bending stress is given by :....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution