Question Set

1. In a disc clutch, if there are n1 number of discs on the driving shaft and n2 number of discs on the driven shaft, then the number of pairs of contact surfaces will be





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A man is facing East, then the turns left and goes 10 m, then turns right and goes 5 m, then goes 5 m to the South and from there 5 m to West. In which direction is he, from his original place ?....
QA->A circular disc of copper has a symmetrical hole at its center. The disc is uniformly heated. The diameter of the hole will?....
QA->John started from his home and walked 12 km.Then he took a right turn and walked 4 km.Then again,he took a right turn and walked 8 km and finally took another right turn and walked 1 km.How far is he from his home now?....
QA->A cyclist goes 40 km towards East and then turning to right he goes 40 km. Again he turn to his left and goes 20 kn. After this he turns to his left and goes 40 km, then again turns right and goes 10 km. I-low far is he from his starting point ?....
QA->Arjun walks 20 m towards North. Then he turns right and walks 30 ms. Again he turns right and walks 35 ms. Then he turns left and walk 15 ms. How far and in which direction Arjun now from his starting point?....
MCQ->In a disc clutch, if there are n1 number of discs on the driving shaft and n2 number of discs on the driven shaft, then the number of pairs of contact surfaces will be....
MCQ->A torsional system with discs of moment of inertia I1 and I2 as shown in the below figure, is gear driven such that the ratio of speed of shaft B to shaft A is 'G'. Neglecting the inertia of gears, the equivalent inertia of disc on shaft B at the speed of shaft A is equal to ....
MCQ->Statements: Some tapes are discs. Some discs are cassettes. Some cassettes are songs. Conclusions: Some songs are discs. Some cassettes are tapes. Some songs are tapes. No song is a disc.

....
MCQ->A shaft has an attached disc at the centre of its length. The disc has its centre of gravity located at a distance of 2 mm from the axis of the shaft. When the shaft is allowed to vibrate in its natural bow-shaped mode, it has a frequency of vibration of 10 rad/s. When the shaft is rotated at 300 r.p.m., it will whirl with a radius of....
MCQ->A slender shaft supported on two bearings at its ends carries a disc with an eccentricity e from the axis of rotation. The critical speed of the shaft is Nc. If the disc is replaced by a second one of same mass but mounted with an eccentricily 2 e, then the critical speed of the shaft in the second case is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution