Question Set

1. In locomotives, the ratio of the connecting rod length to me crank radius is kept very large in order to





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->In a positive crank case ventilation system,the blow by gas drawn from the crank is fed to the :....
QA->The ratio of bases of a cylinder and a cone are in the ratio 3: Volume of cylinder and cone are in the ratio 9: then their heights are in the ratio?....
QA->Connecting rod is attached to the piston by:....
QA->The length and breadth of a rectangular field in the ratio of 12: 7 . Find the length if area of the field is 52,500 Sq.m?....
QA->The ratio of length and breadth of a rectangle is 7: if perimeter is 52 then, what is the length of the rectangle?....
MCQ->In locomotives, the ratio of the connecting rod length to me crank radius is kept very large in order to....
MCQ->The primary unbalanced force due to inertia of reciprocating parts in a reciprocating engine is given by (where m = Mass of reciprocating parts, ω = Angular speed of crank, r = Radius of crank, θ = Angle of inclination of crank with the line of stroke, and n = Ratio of the lengm of connecting rod to radius of crank)....
MCQ->The secondary unbalanced force due to inertia of reciprocating parts in a reciprocating engine is given by (where m = Mass of reciprocating parts, ω = Angular speed of crank, r = Radius of crank, θ = Angle of inclination of crank with the line of stroke, and n = Ratio of the lengm of connecting rod to radius of crank)....
MCQ->In a locomotive the ratio of the connecting rod length to crank radius is kept large in order to:....
MCQ->In the below figure, PC is the connecting rod and OC is the crank making an angle θ with the line of stroke PO and rotates with uniform angular velocity at ω rad/s. The Klien's acceleration diagram for determining the acceleration of the piston P is shown by quadrilateral C Q NO, the acceleration of the piston is zero when the crank OC and connecting rod PC are at right angles to each other. ....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution