Question Set

1. The mode of deformation of the metal during spinning is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->Spinning Frame കണ്ടെത്തിയത്?....
QA->Malabar Spinning and Weaving Mills is situated in?....
QA->Spinning Frame കണ്ടെത്തിയത് ?....
QA->What is the Mode of transmission of heat in which heat carried by a moving particles?....
MCQ->Match the following : a. Acrylic 1. Melt spinning b. Kevla 2. Wet spinning c. PET 3. Dry spinning d. Triacetate 4. Dry-Jet wet spinning....
MCQ->Whenever some external system of forces acts on a body, it undergoes some deformation. As the body undergoes some deformation, it sets up some resistance to the deformation. This resistance per unit area to deformation, is called....
MCQ->The mode of deformation of the metal during spinning is....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->Consider the following statements about 8085 The instruction LDA uses direct addressing mode.The instruction MVI uses direct addressing mode.The instruction MVI uses immediate addressing mode.The instruction LDA uses immediate addressing mode. Which of the above are correct?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution