Question Set

1. The welding process used in joining mild steel shanks to high speed drills, is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Speed of a speed-boat when moving in the direction perpendicular to the direction of the current is 25 km/h, speed of the current is 5 km/h. So, the speed of the boat against the current will be:....
QA->Speed of a speed-boat when moving in the direction perpendicular to the direction of the current is 25 km/h, speed of the current is 5 km/h. So, the speed of the boat against the current will be:....
QA->India govt plan to construct new corridor for high speed train with speed range 300-350 kmph. What is the present maximum speed of long distance train in India?....
QA->Raju Starts from A to B at a speed of 10 km/hr and returns with a speed of 15 km/hr. What is the average speed of the journey ?....
QA->Speed of a swimmer when moving in the direction perpendicular to the direction of the current is 16 km/h, speed of the current is 3 km/h. So the speed of the swimmer against the current will be (in km/h):....
MCQ->The welding process used in joining mild steel shanks to high speed drills, is....
MCQ->The cutting speed for drilling aluminium, brass and bronze with carbon steel drills is __________ cutting speed for drilling mild steel with high speed steel drills.....
MCQ->High speed steel drills can be operated at about __________ the speed of high carbon steel drills.....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->For machining a mild steel workpiece by a high speed steel tool, the average cutting speed is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution