Question Set

1. You type show running-config and get this output: [output cut] Line console 0 Exec-timeout 1 35 Password BIXPASSWD Login [output cut] What do the two numbers following the exec-timeout command mean?




Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.56 am
    The exec-timeout command is set in minutes and seconds.
Show Similar Question And Answers
QA->The sum of squares of two numbers is 80 and the square of difference between the two numbers is Find the product of two numbers.....
QA->If you have a Power point show you created and want to send using E-mail to another teacher you can add the show to your E-mail message as an______....
QA->Correct sentences among the following are: ) The tea is too hot that I cannot drink (2) Work hard, lest you should miss the chance (3) Unless you study well, you will fail (4) Unless you study well, you will pass....
QA->Two statements are given followed by two conclusions I and II. You have to consider the two statements to be true even if they seem to be at variance from commonly known facts. You have to decide which one of the given conclusions is definitely drawn from the given statements. Statement : All virtuous persons are happy. No unhappy person is virtuous. Conclusions : I. Happiness is related to virtue II. Unhappy person is not virtuous.....
QA->A student needed to find the arithmetic mean of the numbers 3, 11, 7, 9, 15, 13, 8, 19, 17, 21, 14 and x. He found the mean to be What is the value of x?....
MCQ->You type show running-config and get this output: [output cut] Line console 0 Exec-timeout 1 35 Password BIXPASSWD Login [output cut] What do the two numbers following the exec-timeout command mean?....
MCQ->You set the console password, but when you display the configuration, the password doesn't show up; it looks like this: [output cut] Line console 0 Exec-timeout 1 44 Password 7098C0BQR Login [output cut] What cause the password to be stored like this?....
MCQ->You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy? Switch(config-if)# ip access-group 10 Switch(config-if)# switchport port-security maximum 1 Switch(config)# access-list 10 permit ip host 1 Switch(config-if)# switchport port-security violation shutdown Switch(config)# mac-address-table secure....
MCQ->To enable EIGRP, which of the following would you use? Router1(config-if)# ipv6 ospf 10 area 0.0.0.0 Router1(config-if)# ipv6 router rip 1 Router1(config)# ipv6 router eigrp 10 Router1(config-rtr)# no shutdown Router1(config-if)# ipv6 eigrp 10....
MCQ->Network 206.143.5.0 was assigned to the Acme Company to connect to its ISP. The administrator of Acme would like to configure one router with the commands to access the Internet. Which commands could be configured on the Gateway router to allow Internet access to the entire network? Gateway(config)# ip route 0.0.0.0 0.0.0.0 206.143.5.2 Gateway(config)# router rip Gateway(config-router)# network 206.143.5.0 Gateway(config-router)# network 206.143.5.0 default....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution