Question Set

1. Which command will configure a switch port to use the IEEE standard method of inserting VLAN membership information into Ethernet frames?






Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.57 am
    If you are on a 2950 switch, then the interface command is just switchport mode trunk, since the 2950 can only run the IEEE 802.1Q version. However, a 3550 can run both ISL and 802.1Q, so you must use the encapsulation command. The argument to choose 802.1Q for a trunking protocol is dot1q.
Show Similar Question And Answers
QA->The Indian Parliament passed the Information Technology Bill , which is regarded as the mother legislation regulating the use of computers, computer systems and computer networks as also data and information in the electronic format , in the year:....
QA->The port in Kerala which was developed by Robert Bristo into a major port?....
QA->By inserting a soft iron piece into solenoid; what does the strength of the magnetic field?....
QA->By inserting a soft iron piece into solenoid, what does the strength of the magnetic field?....
QA->A semiconductor device used to amplify or switch electronic signals and electrical . power?....
MCQ->Which command will configure a switch port to use the IEEE standard method of inserting VLAN membership information into Ethernet frames?....
MCQ->Fact 1: Eyeglass frames cost between $35 and $350. Fact 2: Some eyeglass frames are made of titanium. Fact 3: Some eyeglass frames are made of plastic. If the first three statements are facts, which of the following statements must also be a fact? I: Titanium eyeglass frames cost more than plastic frames. II: Expensive eyeglass frames last longer than cheap frames. III: Only a few eyeglass frames cost less than $35.....
MCQ->You have your laptop directly connected into a router's Ethernet port. Which of the following are among the requirements for the copy flash tftp command to be successful? TFTP server software must be running on the router. TFTP server software must be running on your laptop. The Ethernet cable connecting the laptop directly into the router's Ethernet port must be a straight-through cable. The laptop must be on the same subnet as the router's Ethernet interface. The copy flash tftp command must be supplied the IP address of the laptop.....
MCQ->You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy? Switch(config-if)# ip access-group 10 Switch(config-if)# switchport port-security maximum 1 Switch(config)# access-list 10 permit ip host 1 Switch(config-if)# switchport port-security violation shutdown Switch(config)# mac-address-table secure....
MCQ->Which of the following are unique characteristics of half-duplex Ethernet when compared to full-duplex Ethernet? Half-duplex Ethernet operates in a shared collision domain. Half-duplex Ethernet operates in a private collision domain. Half-duplex Ethernet has higher effective throughput. Half-duplex Ethernet has lower effective throughput.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution