Which one is the proper location for mounting main switch gear in a building? ?->(Show Answer!)

Warning: implode(): Invalid arguments passed in /www/wwwroot/jobquiz.info/mdiscuss.php on line 336
Which one is the proper location for mounting main switch gear in a building? ?->(Show Answer!)

Question Set

1. Which one is the proper location for mounting main switch gear in a building?

Ask Your Doubts Here

Comments

Show Similar Question And Answers

QA->In an automobile gear transmission the counter shaft drive gear is meshed with the gear on the:....

QA->Trivandrum Museum building and the main building of Trivandrum University College were constructed during the reign of ?....

QA->Who exhorted the world famous dictum "One caste, One religion, One clan, One world, One God"?....

QA->A semiconductor device used to amplify or switch electronic signals and electrical . power?....

QA->“One caste, One religion and One God for man of the same blood and form, there is no difference animals of the same caste alone procreate Viewed thus all humanity belong to one caste”- In which book of Sree Narayana Guru these words can be seen?....

MCQ->Which one is the proper location for mounting main switch gear in a building?....

MCQ->You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy? Switch(config-if)# ip access-group 10 Switch(config-if)# switchport port-security maximum 1 Switch(config)# access-list 10 permit ip host 1 Switch(config-if)# switchport port-security violation shutdown Switch(config)# mac-address-table secure....

MCQ->A fixed gear having 200 teeth is in mesh with another gear having 50 teeth. The two gears are connected by an arm. The number of turns made by the smaller gear for one revolution of arm about the centre of bigger gear is....

MCQ->Which of the following sentences are correct about a switch loop in a C program? 1: switch is useful when we wish to check the value of variable against a particular set of values. 2: switch is useful when we wish to check whether a value falls in different ranges. 3: Compiler implements a jump table for cases used in switch. 4: It is not necessary to use a break in every switch statement.....

MCQ->Gear A has a weight of 1.5 lb, a radius of 0.2 ft, and a radius of gyration of ko = 0.13ft. The coefficient of friction between the gear rack B and the horizontal surface is = 0.3. If the rack has a weight of 0.8 lb and is initially sliding to the left with a velocity of (vB)2 = 8 ft/s to the left. Neglect friction between the rack and the gear and assume that the gear exerts only a horizontal force on the rack.....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution