Question Set

1. If the number of all the engineers in the company V, company X and company Y be increased by 30%. 35% and 40% respectively, what will be the overall percentage increase in the number of all engineers of all the companies taken together ?






Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The Direct Tax Code (DTC) task force has recommended a major cut in corporate tax for both domestic and foreign companies. What is the newly recommended corporate tax rate for both domestic and foreign companies?....
QA->If the Kinetic Energy of a body is increased by 300%; how much will its momentum increase?....
QA->If the momentum of a body is increased by 50%; how much will its K.E. will increase?....
QA->If the Kinetic Energy of a body is increased by 300%, how much will its momentum increase?....
QA->If the momentum of a body is increased by 50%, how much will its K.E. will increase?....
MCQ->If the number of all the engineers in the company V, company X and company Y be increased by 30%. 35% and 40% respectively, what will be the overall percentage increase in the number of all engineers of all the companies taken together ?....
MCQ->If the number of assistant engineers employed in all the companies be increased by 37% and the number of post graduate engineers employed in all the companies be decreased by 20%. by what percent will the number of assistant engineers be less than that of post graduate engineers ?....
MCQ->Which of the following would include Foreign Direct Investment in India? 1. Subsidiaries of companies in India foreign companies in India 2. Majority foreign equity holding Indian companies 3. Companies exclusively financed by foreign companies 4. Portfolio investment Select the correct answer using the codes given below :....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->What is the difference between the average number of junior engineers and assistant engineers taking all the companies together ?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions