Question Set

1. The crescent-shaped cavity on the piston head top surface is called as





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Who said ‘Climbing to the top demands strength; whether it is to the top of Mount Everest or to the top of your career’?....
QA->The angle of elevation of the top of a hill at the foot of a tower is 60° and the angle of elevation of the top of the tower from the foot of the hill is 30°. If the tower is 50 m high, the height of the hill is—....
QA->The space between the piston and cylinder is called:....
QA->Bowl shaped depression created as a result of glacial erosion high on a mountainside what is this called?....
QA->A coil of insulated wire bound on a rod shaped form made of solid iron is called?....
MCQ->The crescent-shaped cavity on the piston head top surface is called as....
MCQ->From a homogeneous and isotropic dielectric material of dielectric constant ∈r, a small volume element is taken out creating a cavity. The field can be kept homogeneous if Di. (i.e., electric flux density inside the cavity) and D0 (i.e., electric flux density outside the cavity) are such that....
MCQ->Consider the following statements Bunching of electrons occurs in two cavity klystron amplifier.Bunching of electrons occurs in multi cavity klystron amplifier.Bunching of electrons occurs in reflex cavity klystron amplifier. Which of the above statements are correct?....
MCQ->The following statements relate to the pressure exerted by a fluid on a Submerged curved surface : 1. The vertical component of hydrostatic force acting on a submerged curved surface acts through the centre of volume of the fluid directly above the submerged area. 2. The horizontal component of the force acting on a curved surface is the hydrostatic force acting on the vertical projection of the curved surface. 3. The resultant force on a curved surface acts on the bottom of th6 curved surface. Of these statements :....
MCQ->Wearing locations of rails and their reasons are listed below : 1. Wear at end of rails : Loose fish bolts 2. Wear at sides of rail head : Constant lerake application 3. Wear on the top of rail head on tangent truck : Rigidity of wheel base 4. Wear on top of rail head on curves : Lesser area of contact between wheel and rail Which of the pairs given above are correctly matched ?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution