Question Set

1. For hardening high alloy steel, it is to be heated slowly and uniformly to avoid





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A small piece of wire made from an alloy of lead and tin is used to avoid overloading is?....
QA->A circular disc of copper has a symmetrical hole at its center. The disc is uniformly heated. The diameter of the hole will?....
QA->P, Q, R are three towns on a river which flows uniformly. Q is equidistant from P and R. A man rows from P to Q and back in 10 hrs. He can row from P to R(upstream) in 4 hrs. The ratio of speed of man in still water to the speed of the current is:....
QA->P, Q, R are three towns on a river which flows uniformly. Q is equidistant from P and R. A man rows from P to Q and back in 10 hrs. He can row from P to R(upstream) in 4 hrs. The ratio of speed of man in still water to the speed of the current is....
QA->Stainless Steel ഉണ്ടാക്കാൻ Steel ൻ്റെകുടെ ചേർക്കുന്ന ലോഹം....
MCQ->For hardening high alloy steel, it is to be heated slowly and uniformly to avoid....
MCQ->High alloy steels must be heated slowly and uniformly for hardening,to avoid:....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->The only suitable method for hardening the low carbon steel is case hardening. Which of the following is a case hardening process?....
MCQ->When hardening steel by the carburising process,after the steel has been heated to the correct temperature and for the correct amount of time,furnace is shut off and the steel is:....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution