The maximum deflection of a structure should not normally exceed lesser of the span/350 or ?->(Show Answer!)

Question Set

1. The maximum deflection of a structure should not normally exceed lesser of the span/350 or

Show Similar Question And Answers

QA->How much the time gap between two sessions of the Parliament should not exceed?....

QA->The total number of members in the Legislative Council of a State shall not exceed __ of the total number of members in the State Legislative Assembly.?....

QA->Dr Ambedkar had said that Article ___ should normally remain a 'dead letter' and would be used only in the 'last resort'.?....

QA->Dr. Ambedkar had said the "Article ___ should normally remain a 'dead letter' and would be used only in the 'last resort'.?....

QA->India govt plan to construct new corridor for high speed train with speed range 300-350 kmph. What is the present maximum speed of long distance train in India?....

MCQ->The maximum deflection of a structure should not normally exceed lesser of the span/350 or....

MCQ->Consider the following statements regarding a beam of uniform cross-section simply supported at its ends and carrying a concentrated load at one of its third points : 1. Its deflection under the load will be maximum. 2. The bending moment under the load will be maximum. 3. The deflection at the mid-point of the span will be maximum. 4. The slope at the nearer support will be maximum. Of these statements :....

MCQ->A simply supported beam of span L carries a concentrated load W at its mid-span. If the width 'b' of the beam is constant throughout the span, then, when the permissible bending stress is 'f', the beam's mid-span depth will be....

MCQ->Statement: According to the officials, paucity of funds with the organisation has led to the pathetic condition of this brilliant architectural structure. Courses of Action: Anew architectural structure for the building should be designed. The reasons for the poor condition of the structure should be found out. Grant should be given to improve the condition of the structure.

MCQ->Consider the following statements with ragard to crack formation and its control: 1. The surface width of the crack should not, in general, exceed 0.30 mm for structures not subjected to aggressive environment. 2. When depth of web in a beam exceeds 750 mm, side face reinforcement @ 0.1 percent of web area should be provided on each face. 3. The nominal spacing of main bars in a slab should not exceed three times the effective depth of a solid slab or 300 mm, whichever is smaller. Which of the statements given above is/are correct ?....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution