Question Set

1. While measuring with a metallic tape of 30 m length pull should be applied





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Changing information by a person/a virus while typing the data, from the way it should be entered is called....
QA->A train moving with uniform speed passed a bridge of length 2000 metres in 2 ½ minutes.It took ½ minutes to pass a telephone post.What is the length of the train in metres?....
QA->The length and breadth of a rectangular field in the ratio of 12: 7 . Find the length if area of the field is 52,500 Sq.m?....
QA->A train of length 150 meters took 8 seconds to cross a bridge of length 250 meters. Time taken by the train to cross a telephone post is....
QA->The ratio of length and breadth of a rectangle is 7: if perimeter is 52 then, what is the length of the rectangle?....
MCQ->A standard steel tape of length 30 m and cross-section 15 x 1.0 mm was standardised at 25°C and at 30 kg pull. While measuring a base line at the same temperature, the pull applied was 40 kg. If the modulus of elasticity of steel tape is 2.2 x 106 kg/cm2, the correction to be applied is....
MCQ->While measuring with a metallic tape of 30 m length pull should be applied....
MCQ->If F is the pull applied at the ends of tape in kg, l is the length of tape between end marks in metres, w is the weight of the tape in kg per metre run, then sag correction....
MCQ->The following steps are necessary to obtain sufficient accuracy with the tape : 1. Keeping uniform tension on tape for each measurement: 2. "Breaking" tape on slopes are necessary to keep the tape level. 3. Keeping accurate count of the stations. 4. Keeping the tape on the line being measured. The correct sequence of these steps is....
MCQ->A 30 m steel tape was standardised at 20°C measurements of distances were taken as 15°C. If the coefficient of linear expansion of the material of the tape were 0.00, 00112 degree centigrade, then the error, due to temperature, per tape length would be....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution