Question Set

1. In the circuit of figure the switch is closed at t = 0, At t = 0+ this current through inductance is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.07 am
    Current through an inductance cannot change instantaneously.
Show Similar Question And Answers
QA->At the time of short-circuit; what will be the current in the circuit?....
QA->At the time of short-circuit, what will be the current in the circuit?....
QA->ലോകത്ത് ഏറ്റവും കൂടുതൽ സി സി ടി വി (Closed- circuit television) ക്യാമറകൾ ഘടിപ്പിച്ച മെട്രോ നഗരം?....
QA->Speed of a swimmer when moving in the direction perpendicular to the direction of the current is 16 km/h, speed of the current is 3 km/h. So the speed of the swimmer against the current will be (in km/h):....
QA->A man who can swim 48 m/minute in still water. He swims 200 m against the current and 200 m with the current. If the difference between those two times is 10 minutes, what is the speed of the current?....
MCQ->You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy? Switch(config-if)# ip access-group 10 Switch(config-if)# switchport port-security maximum 1 Switch(config)# access-list 10 permit ip host 1 Switch(config-if)# switchport port-security violation shutdown Switch(config)# mac-address-table secure....
MCQ->The voltage applied to an R-L circuit at t = 0 when switch is closed is 100 cos (100 t + 30°). The circuit resistance is 80 Ω and inductance is 0.6 H (in which initial current is zero). What is the maximum amplitude of current flowing through the circuit?....
MCQ->The switch in figure is initially closed. At t = 0 the switch is opened. At t = 0+, the current through inductance is ....
MCQ->In the circuit of figure the switch is closed at t = 0, At t = 0+ this current through inductance is ....
MCQ->Which of the following sentences are correct about a switch loop in a C program? 1: switch is useful when we wish to check the value of variable against a particular set of values. 2: switch is useful when we wish to check whether a value falls in different ranges. 3: Compiler implements a jump table for cases used in switch. 4: It is not necessary to use a break in every switch statement.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution