Question Set

1. In the circuit of figure, the switch is closed at t = 0 with iL (0) = 0 and VC (0) = 0. In the steady state nc equals.





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->ലോകത്ത് ഏറ്റവും കൂടുതൽ സി സി ടി വി (Closed- circuit television) ക്യാമറകൾ ഘടിപ്പിച്ച മെട്രോ നഗരം?....
QA->At the time of short-circuit; what will be the current in the circuit?....
QA->At the time of short-circuit, what will be the current in the circuit?....
QA->A semiconductor device used to amplify or switch electronic signals and electrical . power?....
QA->സ്ഥിരാവസ്ഥാ സിദ്ധാന്തത്തിന്റെ (Steady State theory) ഉപജ്ഞാതാക്കൾ?....
MCQ->Which two statements are true about wrapper or String classes? If x and y refer to instances of different wrapper classes, then the fragment x.equals(y) will cause a compiler failure. If x and y refer to instances of different wrapper classes, then x == y can sometimes be true. If x and y are String references and if x.equals(y) is true, then x == y is true. If x, y, and z refer to instances of wrapper classes and x.equals(y) is true, and y.equals(z) is true, then z.equals(x) will always be true. If x and y are String references and x == y is true, then y.equals(x) will be true.....
MCQ->You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy? Switch(config-if)# ip access-group 10 Switch(config-if)# switchport port-security maximum 1 Switch(config)# access-list 10 permit ip host 1 Switch(config-if)# switchport port-security violation shutdown Switch(config)# mac-address-table secure....
MCQ->In the circuit of figure, the switch is closed at t = 0 with iL (0) = 0 and VC (0) = 0. In the steady state nc equals. ....
MCQ->Which two statements are true about comparing two instances of the same class, given that the equals() and hashCode() methods have been properly overridden? If the equals() method returns true, the hashCode() comparison == must return true. If the equals() method returns false, the hashCode() comparison != must return true. If the hashCode() comparison == returns true, the equals() method must return true. If the hashCode() comparison == returns true, the equals() method might return true.....
MCQ->In the circuit shown in the figure, steady-state was reached when the switch S was open. The switch was closed at t = 0. The initial value of the current through the capacitor 2 C is ....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution