Question Set

1. For a 2 port network, the O/P short circuit current was measured with a 1 volt source at the I/P then value of the current gives





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->At the time of short-circuit; what will be the current in the circuit?....
QA->At the time of short-circuit, what will be the current in the circuit?....
QA->The current in an electrical circuit is measured by?....
QA->The e.m.f or potential difference measured in volt is called?....
QA->Potential difference measured in volt is called?....
MCQ->For a 2 port network, the O/P short circuit current was measured with a 1 volt source at the I/P then value of the current gives....
MCQ->A dc network has an open circuit voltage of 5 V. When its terminals are short circuited a current of 5 A flows through the short circuit. If the short circuit is removed and a resistance of 1.5 Ω is connected across its terminals, the current will be....
MCQ->You are the administrator of a Windows 2000 Server computer. The server contains one network adapter and is a file and print server for critical company resources. You install a second network adpater in the server and connect it to the same network subnet as the first adapter. You want to ensure that the first adapter is used for all network traffic and the second adapter is used only if the first adapter fails or is disconnected from the network. You also want to ensure that the server always has network connectivity even if one network adapter fails. What should you do?....
MCQ->Which three statements are true about the operation of a full-duplex Ethernet network? There are no collisions in full-duplex mode. A dedicated switch port is required for each full-duplex node. Ethernet hub ports are preconfigured for full-duplex mode. In a full-duplex environment, the host network card must check for the availability of the network media before transmitting. The host network card and the switch port must be capable of operating in full-duplex mode.....
MCQ->A magic tee is to be used as CW duplexer. Then port 1, port 2, port 3 (E arm), port 4 (H arm) respectively should be connected to....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution